Waterproof watch precautions in use
(1) waterproof apron easy to aging deterioration, to regular replacement, or repair each time when a replacement.
(2) Table glass can damage the waterproofing properties of the table are affected, there should also timely replacement of damaged.
(3) Do not watch in the water or moisture, the operator watches handle head, in order to prevent the water table into the machine.
(4) The handle should be pushed in the end after the first use, screw button handle lock on the first pay attention to watch, do not Go out gaps
(5) Watches stained with water to keep dry.
(6) to prevent contact with chemical substances watch, otherwise it will affect the case and waterproof apron, waterproof lower.
(7) Do not watch long placed high temperature (10 60 ℃) and low temperature (-10 ℃) environment.
(8) If the water inside a watch aerosol point, should be promptly removed parts to avoid rust.
5. Quartz watch why should the timely replacement of the battery?
Quartz watch movement and use of under used is different, the battery life of 1-2 years. 3-pin high-grade quartz watch has a battery will run out of prompts, beating second hand abnormalities, that is, four seconds of each jump, then you need a timely reminder to replace the battery, if not timely replacement batteries may cause battery leakage and damage the internal parts watch . Some customers have several pieces watches, usually do not wear when you pull out the crown in order to make energy-saving and stop watch go watch has stopped walking surface, but in fact the battery continues to discharge, if not replaced will cause the battery over-discharge , so that the battery leakage, the same movement will be corrosion, resulting in maintenance cost far more than the cost to replace the battery.
6. Sapphire crystal mirror would do scratches?
Sapphire watch crystal made of sapphire mirror is not natural, but by fine alumina powder as raw material, in certain high-temperature furnace to form Celsius sapphire crystal block, go through numerous processes before watch made of pure unparalleled sapphire crystal with anti-wear and anti-corrosion effect. The hardness of sapphire crystal mirror second only to diamond, equivalent to seven times that of steel, but does not mean that it will not be scratched, sapphire crystal mirror is not easy to wear, rather than never wear. Special attention should be diamonds, terrazzo, sandpaper, nail-down of the granite surface, concrete walls so as to avoid scratches the surface.
7. Quartz watch stopped for any reason to go?
First, look at whether the crown pulled out, it hit the table second hand mirror, mirror on the table there would be a circle mark, whether the three-pin contacts, when the needle with the needle overlap, to see whether through it, the last in the expertise to check the battery is exhausted.
8. Steel strap stain or fade do occur?
Are many kinds of stainless steel, its main ingredient for the nickel and chromium, and nickel, chromium and other elements susceptible to acid-free alkali erosion. Human sweat contains hydrochloric acid composition, wear watches, if the contact or are often left to acid-base salt, sweat, dirt build-up without timely clean-up, strap, etc. will gradually appear rusty spot, wrist will also appear on the black stains. This is mainly due to stainless steel contains nickel and other elements with the human body in sweat or vinegar, bleach, correction fluid and other chemicals, chemical reagents, cosmetics and other substances caused by contact. The general approach is to strap with a soft hair brush dipped in cleaning agent gently wipe with a soft cloth after brushing; or to brand authorized repair station cleaning using ultrasonic instruments.
9. 2-pin quartz Why would often find a minute slower?
Because the two-pin quartz watch most of the motor jump once every 12 seconds, the customer may be adjusted when the motor has not yet started, it will be reflected to the minute hand with the correct difference in time between a minute, if the above situation simply dial minute hand One minute you can.
10. How to solve the mechanical watch magnetic phenomenon?
Once the magnetic watches would suddenly go very fast, even faster than 1-2 hours / day. Usually wear a mechanical watch should pay attention away from the magnetic field, such as audio, TV sets, mobile phones and other electrical appliances in the vicinity. The magnetic current is a relatively common phenomenon, the solution is not difficult, just to the authorized maintenance department demagnetization using specialized equipment, just a short 30 seconds, watches will be able to demagnetization, to watch the performance is not affected. |
